Dip Switch Settings; Access Levels - Kanmor Zone Control 369e Manual

Cleaning
The control's exterior can be cleaned using a damp cloth. Moisten cloth with water and wring out prior to wiping control. Do not
use solvents or cleaning solutions.

DIP Switch Settings

The DIP Switch settings on the control are very important and should be set to the
appropriate settings prior to making any adjustments to the control through the user
interface. The DIP switch settings change the items that are available to be viewed
and / or adjusted in the user interface.
LOCK / UNLOCK
The Lock / Unlock DIP switch is used to lock and unlock the access level of the control and tN1 / tN2 device(s). Once locked,
access levels cannot be changed. To determine if the control is currently locked or unlocked, a small segment representing a
padlock is viewed in the bottom right hand corner of the display. When the padlock is closed, the access level cannot be changed.
To change the access level, set the DIP switch to the unlocked or down position. The current access level of the control or tN1/2
device is viewed in its Miscellaneous (Misc) menu. While viewing the access level, use the up and down keys to select between
the Limited (LTD), User (USER), Installer (INST), or Advanced (ADV) access levels.
To lock the access level, select the appropriate access level in the Miscellaneous (Misc) menu and move the DIP switch from
the unlocked position to the locked position. As long as the DIP switch is in the locked position, the access level of the control
or tN1 / tN2 device can no longer be viewed or adjusted in its Miscellaneous (Misc) menu.
SETBACK / NONE
The Setback / None DIP switch enables and disables the setback functions of the control. When the DIP switch is set to the
None or down position, the control ignores any external setback signal, and its user interface does not display the Unoccupied
adjustments.
When the DIP switch is set to the Setback position, the internal clock in the control is enabled. The control also responds to an
external setback signal generated on the UnO Sw terminal.

Access Levels

The kanmor Zone Control 369e comes with four Access Level settings. These Access Levels restrict the number of Menus,
Items, and Adjustments that can be accessed by the user. The four access levels are Limited (LTD), User (USER), Installer
(INST) and Advanced (ADV).
The access level of the control is found in the Miscellaneous (Misc) menu when the
Lock/Unlock DIP switch is set to the unlocked position. In the Advanced access level,
all of the control settings are available to the user. In the User access level, only a few
of the menus and items are available. The Limited access level is the most restricted of
them all. The control's factory setting is Installer (INST). This access level is sufficient
for the normal set up of the control. Once the control is set up, the appropriate access
level should be selected for the people that deal with the control on a regular basis.
17 of 32
Setback
None
© 2003 D 369e - 06/03