Table of Contents
Advertisement
Installation
CAUTION
Improper installation and operation of this control could result in damage to the equipment and possibly even personal injury.
It is your responsibility to ensure that this control is safely installed according to all applicable codes and standards. This
electronic control is not intended for use as a primary limit control. Other controls that are intended and certified as safety
limits must be placed into the control circuit. Do not open control. Refer to qualified personnel for servicing. Opening voids
warranty and could result in damage to the equipment and possibly even personal injury.
STEP ONE
Check the contents of this package. If any of the contents listed are missing or damaged, please contact your wholesaler or
kanmor sales representative for assistance.
Type 369e includes: One Zone Control 369e, One Outdoor Sensor 070e, Data Brochures D 369e, D 070e,
Note: Carefully read the details of the Sequence of Operation to ensure that you have chosen the proper control for your application.
STEP TWO
Press down at the fingertip
grips on top of the front cover
and pull out and down.
Remove the safety dividers
from the wiring chamber by
pulling them straight out of
their grooves.
The control can be mounted
on a standard DIN rail. This
will be a popular option for
those who prefer to mount
the control inside a larger
electrical panel.
GETTING READY
User Brochure U 369e.
MOUNTING THE BASE
Lift the front cover up and
away from the control.
Release Clip
Press the control release
clip on the base inside the
wiring chamber and slide
the control upwards.
Loosen the screws at the
front of the wiring cover.
The control lifts up and away
from the base.
The wiring can enter the bottom
or the back of the enclosure.
Knock-outs provided in the base
allow the wiring to be run in con-
duit up to the enclosure. The
base also has holes that line up
with the mounting holes of most
common electrical boxes.
12 of 32
The wiring cover pulls
straight out from the
wiring chamber.
13 mounting holes
The base is ready for
mounting. There are 10
conduit knock-outs at
the back and bottom of
the wiring chamber.
© 2003
D 369e - 06/03
Advertisement
Table of Contents
