Digital Dream EC500 User Manual page 23

Click "Spindle Setup" switch to the spindle settings page.
Here we can configure the spindle rotates CW、Reverse CCW、Mist、Flood pin,.They have been
configured as 1、2、3、4. Corresponding to output#1~output#4 in Figure4-11.output#1~output#6 in Output
Signal Setup dialog can be Configured into these 4 signals. Here we only configure CW/MIST/FLOOD. CW
is controlled by OUT1. MIST is controlled by OUT2. Flood is controlled by OUT3. Here we note correspon-
dence between 2 page. Please select "use spindle motor output" if required PWM speed spindle. And select "
PWM Control". Our PWM pin fixedly arranged on a special pin on Stepper motor setting dialog.
Here by our controller we already define all the Output Ports to Port No. 2.
All Output Ports are defined to Port No. 2.
Digital Dream Mach3 Motion Controller
Spindle setting corresponds to the output configuration
Page -21 EC500 User's Manual