Motor Tuning And Setup - Digital Dream EC500 User Manual

6.4 Motor Tuning and Setup

Click Main Menu 'Config',select the 'Motor Tuning' from its pop-down menu:
Then the screen display as below:
Mach3's Menu -> Config -> Motor Tuning (and Setup).
The Step Pulse and Direction Pulse fields are used for a Ethernet Port connection from your computer to
your hardware.
The Steps per Unit, Velocity (Units per Minute) and Acceleration fields are critical for tuning your
motors. The Steps per Unit is determined by your hardware for each axis. The velocity is the maximum
speed you want your axis to move. The acceleration is the maximum acceleration rate your motors should run
at (to prevent stalling or missed steps). This needs to be done for each of your axes.
Don't forget to save the data when you finished the data setting of every axis.For example,you click Z
Axis,and save all the datas into the column,then you must click "SAVE AXIS SETTING",then the datas can
be saved.
Digital Dream Mach3 Motion Controller Page -18 EC500 User's Manual