Installation - NEC Express5800/R120e-2M User Manual

Chapter 2 Preparations

1.18.3 Installation

Install a PCI card to the PCI riser card in the following procedure.
1. See steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Remove the two screw securing the rise
card. Hold the both ends of the PCI riser
card and lift it off.
3. Confirm the installation position with the reference to the table on 1.18.2 Supported boards and
available slots.
4. Remove a screw from the PCI rise card
and remove the blank cover.
5. Install a PCI card to the PCI riser card.
When installing the card, position the
terminal part of the PCI card to the PCI
riser card slot and insert it.
104
Important
When installing a PCI card, make sure the connector of the board fits the
connector of the riser card.
• Check the board type (Low Profile or Full Height) which respective PCI riser
Note
card supports and the type of PCI card to be installed.
• If the battery for RAID controller is installed, see Chapter 2 (1.11 Battery for
RAID Controller).
Note
Keep the removed blank cover for future use.
Important
Do not touch the terminal part of riser cards or PCI cards and the signal pins
of electric parts installed on the board. Installing boards with dirt or oil can
cause malfunction.
Express5800/R120e-2M User's Guide
1. Installing Internal Optional Devices