Table of Contents
Advertisement
16.7 To remove the burner unit.
1. Remove the fascia (See section 16.4).
2. Remove the ceramic fuel effect
3. Support the inlet 'T' connector to avoid straining the pipework and
disconnect the appliance from the inlet 'T' connector.
4. Detach the burner unit from the hotbox by removing two screws
(See figure 40).
5. Replace in the reverse
order.
16.8 To remove the
electronic ignition
generator.
1. Remove the bottom
front and fire front
castings (See section
16.4).
2. Remove the ceramic
fuel effect.
3. Remove the battery.
4. Remove the spark lead.
5. Unscrew the four support bracket screws (See
figure 41). The generator and its support bracket can
now be moved forward. Be careful not to apply
tension to the microswitch leads.
6. Remove the two fixing screws that attach the
generator unit to the support bracket. The igniter
generator can now be removed (See figure 41).
7. Remove the two leads to the switch and remove
the spark lead. If necessary, mark them to ensure
that they are replaced on to the correct terminals.
8. Replace the generator
9. Refit in the reverse order.
INSTALLER GUIDE
Figure 40. Burner attachment points
Page 31
Figure 41. Removal of electronic
ignition generator
Figure 39.
Control slider
Advertisement
Table of Contents
