Table of Contents
Advertisement
The items required for this appliance are packed as below (See figure 6)
1 Burner and hotbox unit.
1 Nut and olive for 8mm inlet pipe.
1 Inlet 'T' connector and pressure test point.
1 Flue restrictor plate.
2 Screws (For flue restrictor).
2 Screws (For fireback spacing brackets).
2 Screws (For rear ceramic wall support bracket).
2 Washers (For fascia hanging).
2 Machine screws (For fascia hanging).
1 Ceramic back wall.
1 Pair of ceramic side walls.
1 Ceramic fuel effect pack (Not shown).
2 Small "U" seals for hotbox side flanges.
1 Strip of floor sealing tape.
6 Fibre plugs.
4 Woodscrews.
2
Fire retaining cables.
2
Cable clamps.
4
Eyebolts.
1
Rubber grommet.
1
PP3 Battery.
1
Knurled shouldered screw (For control linkage fixing).
1
Smoke match tube.
2
Fireback spacing brackets.
1
Rear ceramic wall support bracket.
1
Length of self adhesive foam seal.
1
Self adhesive control position label.
1
Literature pack.
1
Slider control unit .
2
Taptite or countersunk screws (For Slider control unit).
2
Fascia securing brackets.
1
Control position label.
Carefully remove all the contents. Take special care in handling the ceramic walls and the
ceramic fuel effect. After fitting the slide control linkage, take care not to bend or distort
the slide control linkage when handling the fascia.
Check that all the listed parts are present and in good condition.
INSTALLER GUIDE
4. PACK CONTENTS
Page 12
Advertisement
Table of Contents
