Table of Contents
Advertisement
INSTALLER GUIDE
and set at maximum output.
2. After checking, turn off the appliance. Remove
the pressure gauge and replace the test point sealing
screw.
3. Light the appliance. Turn to the maximum output
position and test around the sealing screw for gas
soundness with a suitable leak detection fluid.
When the above checks from section 10.2 and
10.3 have been completed close the isolating
valve on the inlet 'T' connector.
Figure 26. Pressure test point
11. CERAMIC WALLS INSTALLATION
1. Fit the ceramic rear wall inside the "L"
bracket on the back face of the burner
compartment. Push the ceramic wall flat
against the back face of the burner
compartment (See figure 27).
2. Fit the ceramic side walls against the side
faces of the burner compartment. The bottom
edges of the walls should rest in the ledges at
the sides of the firebox. Slide them in from
the front and ensure that they touch the rear
wall. Be careful not to damage the edges of
Figure 27. Ceramic rear wall installation
the side walls (See figure 28).
Figure 28. Ceramic side walls installation
Page 23
Advertisement
Table of Contents
