Table of Contents
Advertisement
16.4 To remove the fascia.
1. Remove the bottom front cover.
2. Detach the control-linking bar from the
control pivot bracket by removing the knurled
screw, which joins the control linking bar to
the control pivot unit (See figure 36).
3. Remove the two screws and washers
securing the bottom of the fascia to the sides
of the hotbox (See figure 37).
4. Make sure that the control linking bar
has been detached (See 2 above). Carefully
lift the fascia unit upward to clear the upper
retaining brackets on the hotbox (See figure
38). Pull the fascia clear and place carefully aside.
5. Refit in the reverse order. Make sure that the
fascia is properly located over the upper retaining
brackets.
16.5 To replace the control slide unit.
1. Remove the fascia (See section 16.4).
2. Detach the slide unit by removing two screws
securing the plastic slide mechanism to the rear of
the fascia (See figure 39).
3. Replace in the reverse order.
16.6 To replace the control slide button.
1. Remove the fascia (See section 16.4).
2. Remove the control slide unit as in section 16.5
3. Detach the slide button by removing two screws
4. Replace in the reverse order.
Figure 38. Fascia top location
(Fascia may differ from that shown)
INSTALLER GUIDE
Page 30
Figure 35. Thermocouple interrupter
block
Figure 36. Control linkage
disconnection (Fascia may
differ from that shown)
Figure 37. Fascia bottom
location (Fascia may differ
from that shown)
Advertisement
Table of Contents
