Cleaning; Servicing, Maintenance And Component Replacement - Lincat Opus 800 OE8013 Installation, Operating And Servicing Instructions

CLEANING

Your product has a manufacturer's warranty. This requires you maintain and care
for your product and follow maintenance instructions. If you fail to maintain your unit
or damage components, Lincat may charge you for a warranty repair. Please check
the website for terms and conditions.
Isolate from the power supply and allow to cool.
Do not use a water jet or steam cleaner, and do not immerse this appliance.
Clean all panels with warm water and mild detergent do not use abrasive or chlorine
based cleaners. Do not wet electrical components. Dry with a soft cloth.
Clean the ceramic glass regularly, avoiding abrasive sponges or scouring agents
and harsh chemicals like oven sprays. Remove dirt and food with a scraper or
Vileda Ceran cleaning sponge.
If plastic, aluminium foil or sugary food has dropped onto hot ceramic glass,
scrape off immediately. If these substances melt they can damage the
surface.
Check the air filters regularly – they are washable if contaminated. Ensure they are
fully dry before refitting.
SERVICING, MAINTENANCE AND
COMPONENT REPLACEMENT
Replacing an air filter
Removing and cleaning the air filter will ensure an adequate supply of cool air and
restore performance. Disconnect from the power supply and allow the appliance to
cool. The filters are located on the base of the unit.
Pull the latch to allow the filter to be lifted away from the base. Remove the filter
and clean – the filter may be put in a dishwasher. Replace the clean filter and re-fit,
ensuring the latch has fully engaged.
Do not operate the appliance without a filter being fitted, otherwise dirt and grease
could be drawn into the electronics, impairing safe operation.
All other servicing, maintenance and component replacement on this appliance
should be carried out by one of our recommended service engineers.
IS 614 ECN 3862 Page 9 of 11