Table of Contents
Advertisement
Locate the pan concentrically over the ceramic glass target ring. If the inner ring of
the ceramic glass is visible around the pan, the pan is too small.
Recommended pan base diameter – minimum of 120mm.
Nominal coil diameter – 220mm.
Power level settings
Constantly variable power level settings are available via the rotary control knob,
Error codes
There are numerous error codes identifying issues within the induction system.
These are primarily of use when reporting a fault to Lincat's Service Department;
however some errors can be cleared by turning the control to the 'Off' position,
unplugging the appliance and then switching back on again.
An illuminated red LED indicates an error.
The generator error codes are displayed in a series of flashes of the green LED.
There is a long flash followed by a series of shorter flashes.
The number of these short flashes is the error number.
A reduction in performance during cooking may be attributed to a blocked or
restricted air filter, a confined location with insufficient airflow or a failed cooling fan.
Exhaust air from the induction hob that can recirculate into the air inlet filter, can
contribute to reduced hob performance.
The air deflector accessory is provided to reduce this air recirculation, see fitting
instructions on page 5.
Pan detection function
Each zone has pan detection which prevents the coil from turning on without a pan
being present. The coil also turns off when a pan is removed.
IS 614 ECN 3862
Page 8 of 11
Advertisement
Table of Contents
