Cleaning; Servicing, Maintenance And Component Replacement - Lincat DK977 Installation, Operating And Servicing Instruction

Error codes
There are numerous 'E' symbol error codes identifying issues within the system which
are primarily of use when reporting a fault to the Service Department at Lincat. Some
errors can be cleared by turning the control off, or completely turning off and
unplugging the appliance before reconnecting.
The 'lightening' symbol reports errors due to the control knob circuit, i.e. if a control
knob is turned anticlockwise and held in excess of 30 seconds in the 'control lock'
position, the system may assume a 'stuck control' and display this symbol.
A situation such as a blocked air filter, failed cooling fan or insufficient air flow to a
confined installation, may cause the generator to overheat, resulting in the 'H' symbol
being displayed. Replacing the air filter, cooling fan or ensuring an adequate air flow
will rectify the issue.

CLEANING

Do not use a water jet or steam cleaner, and do not immerse this appliance.
Clean all panels with warm water and mild detergent, do not use abrasive
materials. Dry with a soft cloth.
Clean the ceramic glass with a scraper or Vileda CERAN cleaning sponge – use a
few drops of a suitable cleaner on a paper towel or the rough side of the sponge.
Wipe with a damp cloth and dry with a clean cloth.
Check the air filter and replace if contaminated (see Component Replacement).
Plastic, aluminium foil or sugary food must be scraped of the ceramic glass
immediately. If these substances melt they can damage the surface.
SERVICING, MAINTENANCE AND
COMPONENT REPLACEMENT
Replacement of air filter
IS 519 ECN 3681 Page 9 of 12