Watchguard AP320 Hardware Manual page 8

Hardware Specifications
Device Indicators in WIPS Mode
These indicators are active when the AP device is set to dedicated WIPS (Wireless Intrusion Prevention System)
mode. For more information about WIPS mode, see the WatchGuard Wi-Fi Cloud help.
Power
Solid green
Solid green
Solid green
Solid green
Solid amber
Solid amber
Solid amber
Solid amber
Solid amber
Off
If the Ethernet connection for an AP320 device drops down to 10/100 Mbps, the amber indicator for
LAN1 will flash while the green indicator for LAN1 remains in its original state. The amber indicator
for LAN1 may continue to flash even if the Ethernet connection switches back to 10/1000 Mbps
mode. These indicators return to normal operation after you restart the AP device.
6
LAN1 LAN2
Solid green On/Off
Solid green On/Off
Solid green On/Off
Slow flash On/Off
Solid green On/Off
Fast flash On/Off
Slow flash On/Off
Any On/Off
Any On/Off
Off Off
2.4 GHz 5 GHz
Solid Solid
green green
Solid Fast flash
green
Solid Slow flash
green
Slow flash Off
Any Any
Any Any
Any Any
Solid Any
Green
Any Solid
green
Off Off
Description
Powered on and operating
correctly. Connected to
WatchGuard Wi-Fi cloud
services.
Troubleshooting in progress on
802.11a/b/g/n.
Intrusion prevention in
progress on 802.11a/n/ac.
Software upgrade in process.
No Ethernet link.
Did not receive a valid IP
address from DHCP.
C annot connect to
WatchGuard Wi-Fi Cloud
services.
Error on 802.11a/b/g/n
interfaces.
Sensor software error.
Not powered on or in startup
process.
WatchGuard AP320