Watchguard AP320 Hardware Manual page 6

Hardware Specifications
Reset Button
Resets the WatchGuard AP device to factory-default settings. You must use a paper clip or other small
object to press the reset button through the small hole on the back of the device.
To reset the device to factory-default settings, power cycle the device (remove the power cable and
reconnect it again). While you reconnect the power source, press and hold the reset button for at
least 60 seconds until the power, LAN1, and 2.4 GHz indicators are green.
USB Port
The USB port connects the AP to a USB device, such as a cellular activity detection device.
4 WatchGuard AP320