Table of Contents
Advertisement
TRANSPORTATION
Refer to Figure 10
WARNING
Risk of unsafe operation. Ensure proper footing and use
caution when rolling the miter saw stand to prevent tipping
or loss of balance.
• Lift up on the end of the miter saw stand with wheels.
• While holding the stand with one hand, squeeze the
release levers and fold up the two suspended legs. The
legs will lock into place.
• Lower the stand until the wheels rest on a flat surface.
• Using the handle, tilt the other end of the miter saw
stand up and transfer the weight to the wheels.
• Squeeze the release levers and fold up the remaining
two legs. The legs will lock into place.
• Holding the handle, carefully lower the stand to the
ground.
GENERAL MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use
of any other parts may create a hazard or cause product
damage. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
WARNING
Keep the miter saw stand dry, clean, and free from oil and
grease. Always use a clean cloth when cleaning. Never
use brake fluids, gasoline, petroleum based products
or any strong solvent to clean the miter saw stand .
Chemicals can damage, weaken or destroy plastic which
may result in serious personal injury
• To move the stand, use handle to lift and tilt the miter
saw stand onto the wheels. Move miter saw stand as
shown.
Figure 10
MAINTENANCE
ADJUST QUICK RELEASE BRACKET
Refer to Figure 11
The quick release mounting brackets must be secure on
the miter saw stand. If adjustment is needed:
Turn the adjusting nut on the adjustment screw clockwise
to tighten the clamping tension.
Turn the adjusting nut on the adjustment screw
counterclockwise to loosen the clamping tension.
Figure 11
Adjustable
Nut
5
5
5
Advertisement
Table of Contents
