Table of Contents
Advertisement
TRANSPORTATION
Refer to Figure 9
WARNING
Risk of unsafe operation. Ensure proper footing and use
caution when rolling the miter saw stand to prevent tipping
or loss of balance.
• Lift up on the end of the miter saw stand with wheels.
• While holding the stand with one hand, squeeze the
release levers and fold up the two suspended legs. The
legs will lock into place.
• Lower the stand until the wheels rest on a flat surface.
• Using the handle, tilt the other end of the miter saw
stand up and transfer the weight to the wheels.
• Squeeze the release levers and fold up the remaining
two legs. The legs will lock into place.
• Holding the handle, carefully lower the stand to
the ground.
• To move the stand, use handle to lift and tilt the miter
saw stand onto the wheels. Move miter saw stand
as shown.
NOTE: With saw removed the stand may be carried by
the carry handle.
GENERAL MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use
of any other parts may create a hazard or cause product
damage. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
Figure 9
MAINTENANCE
WARNING
Keep the miter saw stand dry, clean, and free from oil and
grease. Always use a clean cloth when cleaning. Never
use brake fluids, gasoline, petroleum based products
or any strong solvent to clean the miter saw stand .
Chemicals can damage, weaken or destroy plastic which
may result in serious personal injury
5
5
5
Advertisement
Table of Contents
