Table of Contents
Advertisement
Electric Brake:
Your stacker is equipped with an electric magnetic
brake. The brake is applied when the handle is in its
vertical position between 10 – 15 degrees and lowered
position between 80 – 90 degrees. The brake could be
released when you pull down the handle at any point
between 15 – 80 degrees. Always make sure the brake is
released before operating the stacker. When the stacker
is running, you could brake the stacker by raising the
handle to its vertical position or lowering the handle to
its lowest position. Or, to turn the butterfly controls in
the opposite direction, the change in direction of the
motor will slow down, stop, and reverse the direction
of stacker. When parked, the handle will spring back
to the full vertical position with the brake applied and
the forks in lowered position.
Reversing Safety:
At the end of the handle there is a large, red reversing
bar (belly button switch) that is designed to protect
the operator from injury. When the operator runs the
stacker backwards, and the end of the handle comes
in contact with the operator's body, the stacker will
automatically reverse direction and travel away from
the operator. When the reversing safety bar comes in
contact with your body during operation, immediately
release your hands from the butterfly control and put the
handle up to its vertical position or down to its lowest
position and the brake is on. The reversing safety bar
will automatically resume to its original position after
being activated.
Horn:
As standard equipment, a horn that is located on the
top of the handle.
AUTHORIZED OPERATORS SHOULD READ
AND UNDERSTAND ALL INSTRUCTIONS,
PRECAUTIONS AND WARNINGS.
IMPROPER USE OF THIS LIFT TRUCK
COULD RESULT IN INJURY AND/OR
DAMAGE TO LOAD AND EQUIPMENT.
•
Inspect the lift for damaged or worn parts.
PRESTO OWNER'S MANUAL
Do not use if not in safe operating condition.
•
Use lift on hard level surfaces only.
•
Make sure load is evenly distributed, not
loose or unstable, and is as far back on platform
or forks as possible. Do not pick up loads on tips
or forks or edge of platform.
•
For fork models, adjust forks to the maxi-
mum practical width. Pick up loads on both
forks.
•
Do not overload. Check load center and load
weight capacities on the nameplate.
•
Make sure travel and work area is clear of
obstructions.
•
Check overhead clearance before lifting
loads or transporting.
DAILY OPERATIONS
B.
MAINTENANCE CHECKS:
1.
Battery
A. Check for corroded and loose terminals.
A white powder substance will be present if
there is any existing corrosion.
B. Visually inspect for any cracks or damage
to the casing.
C. Check for loose battery tie-downs.
2.
Charger
A. Inspect wire connections.
B. Check power cord for nicks/damage.
C. Check power charger for proper mounting.
3.
Hydraulic System
D. Inspect pump and cylinder for oil leaks.
E.
Check hydraulic oil level.
F.
Check hydraulic fittings and hoses.
G. Check ram for nicks/damage.
4.
Frame Assembly
A. Check chain roller assembly connections.
B. Check for any worn or damaged parts.
Page 11
POWER STAK
Advertisement
Table of Contents
