Ddec Iii/Iv Options - Detroit Diesel 60 Series Operator's Manual

Before attempting to jump start the
engine, make sure jumper cables are
connected properly (positive to positive,
negative to negative) and in the proper
sequence (negative to negative last).
NOTICE:
Failure to observe this precaution
can result in alternator and/or equip-
ment damage.
CAUTION:
To avoid injury from battery explo-
sion or contact with battery acid,
work in a well-ventilated area,
wear protective clothing, and
avoid sparks or flames near the
battery. Always establish correct
polarity before connecting cables
to the battery or battery circuit. If
you come in contact with battery
acid:
Flush your skin with water.
Apply baking soda or lime to
help neutralize the acid.
Flush your eyes with water.
Get medical attention immedi-
ately.

DDEC III/IV OPTIONS

Detroit Diesel Series 60 engines
equipped with DDEC III or DDEC IV
electronic control systems are identified
by a "K" in the sixth position of the
model number. Example: 6067GK60.
Detroit Diesel Electronic Controlled
Series 60 engines can be equipped
with a variety of options designed to
warn the operator of an engine mal-
function. The options can range from
"Check Engine" and "Stop Engine"
panel lights (see Figure 6) to automatic
reduction in engine power followed by
automatic engine shutdown. The
power-down/shutdown option may be
activated by low coolant level, low oil
pressure or high engine oil or coolant
temperature.
STOP ENGINE CHECK
OVERRIDE
DIAGNOSTIC
SWITCH ENGINE
Figure 6. Typical Shut-Down Override
Switch and Engine Lights
NOTICE:
If the warning lights stay on, or if they
do not come on momentarily after
turning on the ignition, consult with a
DDEC technician. Operating the
engine under these circumstances
may result in engine damage.
The Series 60 DDEC engine is
equipped with an electronically con-
trolled fuel injection system. There
9
STOP
ENGINE