Table of Contents
Advertisement
Operation Guide (cont'd)
Setup and Guide for Grooming Driveways (cont'd)
Pass 2
Pass 3
The dotted line indicates the center or "crown" of the driveway.
This pattern will need to be run a few times at a very slow steady speed. While going down the driveway, make
sure to overlap the pattern. Overlap should be about 6" or enough to remove the ribbon from the previous pass.
When finished running the pattern, go back over it again using the finish rake at a slow and steady speed to give a
finished look.
Another pattern to use is the Crossover Serpentine Pattern. This is the same as the pattern above, but now work
the driveway from each side. This is a down and back pattern. The pattern is illustrated below:
Pass 1
Drag Direction -
Pass 2
Drag Direction -
Pass 3
Drag Direction -
The white arrows indicate the first pass. The gold arrows are the second, and the black arrows the third. Go down
the driveway in the same slow serpentine pattern, then starting at the bottom, repeat the pattern continuing up
and down the driveway until the waves are fully removed.
Visit: www.abisupport.com
14
Components
Rascal Arena Pro/Gravel Pro
Finish Rake/Comb
Breaks up clumps of material and leaves a beautiful
signature finish. By adjusting the rear manual jack, the 1/2"
thick hardened-steel-rake, can pivot up to 90° into a variety
of finishing and grading positions. This adjustability enables
the rake to pulverize clods of material, level and finish no
matter the material consistency. Finish Rakes are made
up of smaller sections that can be individually ordered to
decrease cost when needing to replace a worn/damaged
tooth.
Email: support@abiattachments.com
FINISH RAKE
Call Toll Free: 877-788-7253
15
Advertisement
Table of Contents
