Troubleshooting; Service Information - Black & Decker STEAMITT FSH10SM Manual

ENGLISH
After use (Fig. E)
Turn the SteaMitt 'OFF'. Turn the steam operation button
TM
u
(1) to off and then press the ON/OFF button (5).
Wait until the SteaMitt
TM
u
Unplug the SteaMitt TM from the electrical wall outlet.
u
Empty the water tank.
u
Remove the cleaning pad (9) and wash it ready for next
u
use.

Troubleshooting

If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Problem Step
The SteaMitt TM is not 1.
turning on
2.
3.
The SteaMitt is not 4.
TM
producing steam
5.
The SteaMitt TM stops 6.
producing steam
during use
The SteaMitt is 7.
TM
producing too little
steam during use
Steam is escaping 8.
from unexpected
areas of the unit.
Where can I get 9.
further information /
accessories for my
steam mop

Service Information

Black & Decker offers a full network of company-owned and
authorized service locations throughtout Asia. All Black &
Decker Service Centers are staffed with trained personnel to
provide customers with efficient and reliable product service.
Whether you need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker location
nearest to you.
NOTE
Black & Decker's policy is one of continuous improve-
u
ment to our products and, as such, we reserve the right to
change product specifications without prior notice.
Standard equipment and accessories may vary by country.
u
Product specifications may differ by country.
u
Complete product range may not be available in all coun-
u
tries. Contact your local Black & Decker dealers for range
availability.
6
(Original instructions)
cools down.
Possible solution
Check the unit is plugged in at the
wallsocket.
Check the unit is switched on using the
ON/OFF switch (5)
Check the fuse in the plug.
Turn on the steam switch (1) After a few
seconds steam will be produced.
Check that the water tank is full.
Check step 5, then 3.
Check step 5.
Refer to the assembly chapter of the
manual for correct fitting instructions of
all parts and accessories. Check for any
signs of tears or rips in the SteaMitt
or cleaning pads. If this continues, stop
using the unit.
www.blackanddecker.co.uk/steammitt
www.blackanddecker.ie/steammitt
TM