Troubleshooting - Black & Decker SteaMitt FSH10SM Original Instructions Manual

ENGLISH
Warning! The SteaMitt should not be used without fitting a
TM
cleaning pad.
Use
Switching on and off
To switch the appliance on, press the ON/Off button (5). It
u
takes approximately 15 seconds for the SteaMitt
up.
Note: always have your hand inside the SteaMitt
press the steam button.
To produce steam, press the steam button (1) on top of
u
the unit.
To switch the appliance off, turn off the steam switch (1)
u
then press the ON/OFF button (5).
Caution! Always empty the SteaMitt
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
Hints for optimum use
General
For optimal cleaning results never use the SteaMitt
u
without first attaching a cleaning pad.
Do not use chemical cleaners or any other additives with
u
your SteaMitt .
TM
Delicate surfaces, mirrors for example, should be cleaned
u
first while the pad is at its driest, thereby avoiding streaks.
Do not use the SteaMitt
u
as damage may be caused by the sudden change in
temperature.
Caution! It is important to monitor the water level in the water
tank (6). To refill the water tank and continue to sanitize/clean
turn the SteaMitt 'OFF'. Unplug the unit from the electrical
TM
wall outlet, refill the water tank (6).
@
Warning! Always use the SteaMitt
E, with your hand inside the protective glove.
@
Warning! Never attempt to use the SteaMitt
gripping it externally as shown in figure F. This will result
in scalding.
@
Warning! Avoid using the SteaMitt
shown in figure H.
@
Warning! Should a problem occur during use, use the
quick release tab (8) to quickly remove the SteaMitt
from your hand as shown in figure I.
After use (Fig. E)
Turn the SteaMitt 'OFF'. Turn the steam operation button
TM
u
(1) to off and then press the ON/OFF button (5).
Wait until the SteaMitt
TM
u
Unplug the SteaMitt from the electrical wall outlet.
TM
u
Empty the water tank.
u
(Original instructions)
to heat
TM
before you
TM
water tank after use.
TM
TM
on cold glass, such as windows
TM
as shown in figure
TM
by
TM
in tight corners as
TM
cools down.
(Übersetzung der ursprünglichen
remove the cleaning pad (9) and wash it ready for next
u
use.
Technical Data
Voltage V
Power W
Tank Capacity ml
Weight kg

Troubleshooting

If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Problem
TM
The SteaMitt is
not turning on
TM
The SteaMitt is
not producing
steam
TM
The SteaMitt
stops producing
steam during use
TM
The SteaMitt is
producing too little
steam during use
Steam is escaping
from unexpected
areas of the unit.
Where can I get
further information /
accessories for my
steam mop
(Übersetzung der ursprünglichen
Verwendungszweck
TM
Ihr BLACK+DECKER
Desinfizieren und Reinigen von Fliesen, Arbeitsflächen,
Küchen und Badezimmern entwickelt. Dieses Gerät darf
nur im Innenbereich verwendet werden und ist nicht für den
gewerblichen Einsatz vorgesehen.
Der Wassertank (6) sollte nur in horizontaler Position auf einer
Arbeitsplatte oder dem Boden verwendet werden.
DEUTSCH
Anweisungen)
FSH10SM FSH10SM1
230 230
ac
1000 1000
100 100
1.65 1.65
Step Possible solution
1. Check the unit is plugged in at the wall
socket.
2. Check the unit is switched on using the
ON/OFF switch (5)
3.
Check the fuse in the plug.
4.
Turn on the steam switch (1) After a few
seconds steam will be produced.
5. Check that the water tank is full.
6.
Check step 5, then 3.
7. Check step 5.
8.
Refer to the assembly chapter of the
manual for correct fitting instructions of
all parts and accessories. Check for any
signs of tears or rips in the SteaMitt
cleaning pads. If this continues, stop
using the unit.
9.
www.blackanddecker.co.uk/steammitt
www.blackanddecker.ie/steammitt
DEUTSCH
Anweisungen)
FSH10SM SteaMitt
TM TM
FSH10SMP
230
1000
100
1.65
TM or
wurde zum
7