Troubleshooting - Black & Decker BHSM15FX08 Original Instructions Manual

ENGLISH
Wall storage (Fig. J-N)
(Available with BHSM15FX10)
The wall storage unit (16) comes in three pieces: Wall bracket
(16a), storage hook (16b), and storage box with lid (16c).
NOTE: When mounting to a wall, ensure the mounting method
is suitable for the wall type and is appropriate for the weight of
the appliance.
1. Mark the location of the wall bracket screw holes onto the
wall. Ensure the wall bracket (16a) is placed at a height that
allows the appliance to hang without hitting the floor.
2. Secure the wall bracket (16a) to the wall using
appropriate screws and anchors for the type of wall and
weight of the appliance.
NOTE: Screws and wall anchors are provided for typical
drywall installation and may need to be replaced with
other fasteners for different wall types.
3. Clip storage hook (16b) to the right side of the
wall bracket (16a) as shown in fig. K. Rotate the storage
hook (16b) upwards as shown in fig. L. Snap the storage
hook (16b) into place by pressing down as shown in fig. M.
4. The storage hook (16b) allows you to hang the cable cleanly.
5. Slide the storage box with lid (16c) onto the
wall bracket (16a) using the rail system provided.
Any accessories not being stored using the on pole
storage accessory (23) can be stored in the storage box
with lid (16c).
NOTE: When using the wall storage, store the handheld
steam unit (3) with floor extension (7) and floor cleaning
head (8) attached in the right-side opening of the wall
storage unit (16) as shown in fig. N. The small countertop
mop head (10) attachment can be placed in the left-side
opening. All other attachments can be stored in the storage
box (22). To avoid damage to the handheld steam unit (3),
never attempt to store the steam mop unit without the floor
extension attached, as it will not be secured in place.
14
(Original instructions)
Technical Data
Voltage
V
ac
Power W
Tank Capacity ml
Weight kg

Troubleshooting

If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Problem Step
1.
The steam mop is not
2.
turning on
3.
4.
The steam mop is not
producing steam
5.
6.
The steam mop stops
producing steam 7.
during use
The steam mop is
producing too much 8.
steam during use
The steam mop is
producing too little 9.
steam during use
Where can I get further
10.
information/accessories
BHSM15FX08 BHSM15FX10
230
1500
500
2.6
Possible solution
Check the unit is plugged in at the wall socket
Check the unit is switched on using the
ON/OFF switch (1)
Check the fuse in the plug
The steam mop will only produce steam
once the unit is switched on, the boiler has
heated up for 30 seconds and then the
steam flow button has been pressed on
Check that the water tank is full. Note: When
first filled or after running dry it can take up
to 45 seconds for steam to be produced
Check steps 1, then 2, then 3, then 4
Check steps 4, then 5, then 3
The unit has two steam flow settings. Set
the steam flow to low steam by pressing
the button
The unit has two steam flow settings. Set
the steam flow to high steam by pressing
the button
www.blackanddecker.co.uk/steammop
www.blackanddecker.ie/steammop
230
1500
500
2.6