Advertisement
Installation procedure
1
Indication marks
Indication
LED
1. Detach the detector from it's base by turning it anticlockwise until the side marks are aligned.
2. Install the base with the included mounting parts (point 5).
3. Connect the power cables (respect to polarity) according to the installation requirements (Figure
1,2).
4. Place carefully the detector, so as to align the side marks and turn it clockwise all the way. Power
the device and after 3-5 seconds will be ready to operate.
CONNECTION
1. IN-OUT -L : It is connected to the loop's (-L).
2. IN +L : It is connected to the loop's (+L).
3. OUT +R and -R : It is connected with the external LED.
Loop
Loop
Figure 2.
Page 2 of 3
Mounting base
2
5
5
Figure 1.
Address seting
Loop
with BSR-2143
(refer to it's
instuction manual)
Loop
photo. 1.
921606004_09_002
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
Connection
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
with external
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
LED
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
+
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
R
not the buyer the transportation cost.
HEAD OFFICE
72
klm old highway Thessaloniki-Katerini,
nd
P.O. 60061 Kolindros, Pieria Greece
www.olympia-electronics.gr
info@olympia-electronics.gr
Page 3 of 3
921606004_09_002
Advertisement
