ESP HDVIEW HDV8RX User Manual page 11

HDV8RX 8 channel.qxp_Layout 2 17/03/2015 15:01 Page 11
There are no cameras displayed on the monitor
• The camera power supply is not correctly connected or damaged
• The camera signal cable is not correctly connected or damaged
• Try another channel input if connecting an analogue camera to the system
• There is a connection issue with the monitor
Real-time image problems (eg. mono picture)
• Set Video Standard option to PAL in the General menu on the DVR
• The signal from the camera is too weak due to excess distance between camera and DVR.
• The colour and brightness setting of the DVR are incorrect, enter the Shortcut menu for Colour
settings
I cannot find the video files in Playback mode
• Recording did not take place in the specified time range
• The recording parameters have not been programmed correctly / switched off
• Hard drive has been overwritten
• Hard drive cannot be detected
DVR cannot detect hard disk
• The DVR's power supply is not correctly connected or damaged
• The DVR has an incorrect power supply
• The HDD has not been connected correctly
• An incorrect HDD has been installed
The images appear unstable during playback
• The recommend setting for 720p playback is 1 channel only
• Frame rate is set to a low rate, enter the Encode menu and adjust the frame rate for future
recordings
Network connection to DVR is not stable
• Network is not stable
• DVR is not networked correctly
• Incorrect network details have been entered in remote viewing platform
During remote viewing the image is not clear or the image is unstable
• Broadband connection is not stable enough to support 720p streaming. Select Extra Stream as
opposed to Main Stream where applicable.
11