Additional Parameters For The Analogue Output - Pepperl+Fuchs DA6-SSI/A-U Manual

DA6-SSI/A-U

4.3. Additional Parameters for the Analogue Output

The following additional settings for the analogue output appear in the Basic Menu:
Menu
Analogue Characteristics
You can set the following output options:
+/- 10 V (bipolar),
0 - 10 V (positive only),
4 - 20 mA
0 - 20 mA.
With setting +/-10 Volts the polarity of the output
voltage will follow the sign in the display
Analogue Offset:
Set this parameter to 0 when you expect your
analogue signal to start with 0 V (or 0 mA / 4 mA
respectively). Where another zero definition is
desired it can be set by this parameter. Setting of
e.g. 5.000 will already produce 5 volts with the
output in zero state.
Analogue Gain:
Parameter to set the analogue output swing. Setting
10.00 will allow full swing of 10 V or 20 mA, setting
8.00 will reduce the swing to 8 V or 16 mA.
The following Operational Parameters provide scaling of the analogue output:
Menu
Analogue-Begin
Start value of the analogue conversion range
Analogue-End
End value of the analogue conversion range
By means of these two parameters any window of the whole display range can be mapped onto
the analogue output.
IX34510a_e.doc / Apr-11
Setting Range Default
-9,999..+9,999 0,000
00,00..99,99 10,00
Setting Range Default
-199999...999999
-199999...999999 100000
Page 18 / 43
0