Product Crushes At The Top Of The Load; Excessive Film Breaks - Lantech QL-400 Manual

8.3.3

Product Crushes at the Top of the Load

Crushes Top of Load
There can be damage to the top of the load even with the correct Containment Force.
Problem The product is crushed at the top of the load
Solution Decrease the Film Tension on the top of the load
Solution Decrease the Film Coverage at the top of the load.
• Select Protected by Load Guardian
• Select Top
• Remove 1 layer on the top of the load
Solution Lower the wrap height
8.3.4

Excessive Film Breaks

Excessive Film Breaks
Common causes of film breaks are:
Problem Film Quality
Solution Decrease the Film Tension
Solution Change to a premium film
Solution Examine the film for:
• Cuts
• Damaged Edges
• Damaged Core
• Other Defects
Problem Sharp corners at the top of the load and inboard loads.
Solution Make a load specific profile for an inboard condition.
• Decrease the Film Tension at the top or the bottom of the load.
• Increase the Film Coverage at the bottom of the load, or decrease the Film
Coverage at the top of the load.
• Lower the Film Height Above the Load
APPENDIX – HELP SCREENS
89