Zanussi ZBC40440 User Manual page 31

Hide thumbs Also See for ZBC40440:
Table of Contents

Advertisement

Available languages

Available languages

Connecting the appliance to the power
supply
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or it
should be possible to isolate the oven from
the supply by incorporating a switch in the
fixed wiring in accordance with the wiring
rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the cupboard,
see (A).
If connection is to be made to position (A),
remove the clip from position 14 on the
rear of the oven (see page 7) and use the
clip to secure the power supply cord to the
top of the housing unit (see page 30).
When not connecting the power supply
cord to position (A), the power supply cord
should be routed under the oven.
• Connect the appliance to a single phase
230 V-240 V/50 Hz alternating current via
a correctly installed earth socket.
• If the appliance is to be operated in a non-
European country, the supply voltage,
current type and frequency of the
appliance indicated on the rating plate
must correspond with the specification of
your power supply. The rating plate can be
found on the inside face of the control
panel.
31
TINS_B110URR0 1_Arabic-2.pdf 31
(A)
• The power supply cord may only be
replaced by an electrician.
• Before installing, tie a piece of string to the
power supply cord to facilitate connection
to point (A) when the appliance is being
installed.
• When inserting the appliance into the
high-sided cupboard, DO NOT crush the
power supply cord.
• Do not immerse the power supply cord or
plug in water or any other liquid.
Electrical connections
WARNING!
THIS APPLIANCE MUST BE
EARTHED
The manufacturer declines any liability should
this safety measure not be observed.
• If the plug that is fitted to your appliance is
not suitable for your socket outlet, it must
be cut off and the appropriate plug fitted.
• Remove the fuse from the cut off plug. The
cut off plug should then be disposed of to
prevent the hazard of shocks in case it
should be plugged into the 13 A socket in
another part of your home.
www.zanussi.com
16/04/2015 12:07:09

Advertisement

Table of Contents
loading

Table of Contents