Deployment Mode; Figure 29: Update The Sensor Configuration; Figure 30: Copy The Token - Geokon GeoNet 8900 Series Instruction Manual

14. Click Update Info to save the sensor configuration.

FIGURE 29: Update the Sensor Configuration

15. Repeat steps 12 – 14 for all loggers on the Network.
16. Click Connections, then enter a token name in the Create Token field.
17. Click Create Token. A new token entry displays.
18. Click the blue token to copy it to the Windows Clipboard.

FIGURE 30: Copy the Token

19. Paste the token into
GEOKON
commission the Cellular Gateway and retrieve data.

3.7 DEPLOYMENT MODE

There are two modes of operation: Deployment mode and Normal mode.
Deployment mode allows loggers to be quickly added to a network and verified.
Put the gateway into Deployment mode before making any changes, such as
adding loggers (during initial setup or later), resetting loggers, or resetting the
gateway.
The gateway enters Deployment mode upon power up, pressing the Status
button, or system reset.
■
To start Deployment mode, press and release the Status button on the
gateway.
■
To reset the system, press and hold the Status button for 10 seconds.
CAUTION! DO NOT reset the gateway unless it is in
Deployment mode.
For information on the function of the Status button, see Section 3.8.
When the network is in Deployment mode, the network status will be indicated by
the LEDs on the gateway approximately every 10-15 seconds.
MODEL 8900 SERIES GEONET WIRELESS DATA HOSTING SYSTEM | NETWORK INSTALLATION | 21
's data collection software, "Agent", to
29:
30: