Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for dallmeier Panomera Air Blast Kit
Summary of Contents for dallmeier Panomera Air Blast Kit
- Page 1 Installation of an Panomera® Air Blast Kit on a Panomera® S4/8 Preparation Panomera® S4/8 Push down the locking pin of the locking ring. Remove the locking ring. Loosen the screws of the Mountera® Plug. © 2021 Dallmeier electronic V1.2.0 2021-01-14...
- Page 2 Installation of an Panomera® Air Blast Kit on a Panomera® S4/8 Remove the Mountera® Plug. Loosen the screw of the cover system on the back of the housing. Pull the cover system back and press the guide rails together. © 2021 Dallmeier electronic V1.2.0 2021-01-14...
- Page 3 Panomera® S4/8 Installation of an Panomera® Air Blast Kit on a Panomera® S4/8 Remove the cover system from the housing. Loosen and remove the screws of the housing cover. Lift off the housing cover. © 2021 Dallmeier electronic V1.2.0 2021-01-14...
- Page 4 Remove the three sealing rubbers. Insert the two air pressure valves at the connection points and tighten them. Insert the coupling valve and tighten it. ATTENTION: Place and tighten vertically to avoid damage to the thread. © 2021 Dallmeier electronic V1.2.0 2021-01-14...
- Page 5 Place the sealing ring on the screw of the compressed air coupling. ATTENTION: The rubber nose of the sealing ring should rest on the two cable valves. Put the camera cover back on the camera and tighten the screws. © 2021 Dallmeier electronic V1.2.0 2021-01-14...
- Page 6 Insert and tighten the air coupling valve for the air hose to the compressor. NOTE: Select the angle valve or vertical valve that you want to use on site for the connection. Alternative: © 2021 Dallmeier electronic V1.2.0 2021-01-14...
Need help?
Do you have a question about the Panomera Air Blast Kit and is the answer not in the manual?
Questions and answers