Fuel Tank Replacement - Toro Z MASTER 2000 Series Service Manual

Seat Removal (continued)
Seat Installation

Fuel Tank Replacement

Fuel Tank Removal
Chassis: Service and Repairs
g336087
1. Bolt
6. Unlatch the seat, then move the seat rearward, out of the way of the motion
control box. Lift the seat off of the machine.
1. Place the seat on top of the fuel tank retainer plate.
2. Move the seat forward, aligning the holes in the seat pan with the holes in
the motion control box.
Note: Make sure the flange bushing is present in each side of the seat pan.
3. Install the bolt and seat pivot on each side of the seat.
4. Raise the seat and attach the wire harness to the operator presence switch.
5. Lift and lower the seat to verify proper function of the seat pivots and the
seat latch.
6. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Note: The fuel pick-up system is designed to pull fuel from any part of the tank in
low fuel situations as well as reducing the affect of debris in the tank.
Figure 31
2. Seat Pivot
Page 5–16 2000 Series Z MASTER® Service Manual
3438-778 Rev A