Adjusting The Park Brake - Toro Z MASTER 2000 Series Service Manual

Park Brake Handle Assembly Installation (continued)

Adjusting the Park Brake

2000 Series Z MASTER® Service Manual
3438-778 Rev A
g336060
4. Secure with a locking cotter pin.
5. Cycle the park brake lever to ensure that it locks in the engaged position.
6. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop, and remove the key. Engage the
parking brake.
2. Raise and support the unit so that the drive wheels are off the ground.
3. Release the drive wheel bypass valves so that the drive wheels are able
to spin freely.
4. Engage and disengage the brake and check each drive tire to make sure that
the brake engages and disengages.
5. If adjustment is necessary, disengage the park brake. Remove the locking
cotter pin from the upper brake linkage.
g336038
Figure 45
Figure 46
Page 5–25 Chassis: Service and Repairs