Using The Drive Wheel Release Valves (Bypass Valves); Adjusting The Motion Control Linkage (Neutral Setting) - Toro Z MASTER 2000 Series Service Manual

Using the Drive Wheel Release Valves (Bypass Valves)

Adjusting the Motion Control Linkage (Neutral Setting)

2000 Series Z MASTER® Service Manual
3438-778 Rev A
The drive wheel release valves are located on the left and right sides underneath
the engine block.
1. Park the machine on a level surface and disengage the PTO. Stop the engine,
wait for all moving parts to stop, and remove the key. Engage the park brake.
2. Locate the bypass levers behind the seat near the drive wheels, on the left
and right side of the frame.
3. To push the machine, loosen the hand screws, move both bypass levers
rearward, and tighten the hand screws to lock into place.
4. Disengage the park brake before pushing the machine.
g336200
1. Run Position
5. To run the machine, move the bypass knobs to the forward position and
lock them into place.
Located on either side of the machine, below the seat are the pump control
linkages. Rotating the end nut with 1/2 inch deep socket wrench allows
fine tuning adjustments so that the machine does not move in neutral. Any
adjustments should be made for neutral positioning only.
Engine must be running and drive wheels must be turning so
adjustments can be performed. Contact with moving parts or hot
surfaces may cause personal injury. Keep fingers, hands, and
clothing clear of rotating components and hot surfaces.
Figure 71
2. Push Position (Disengage Park Brake)
WARNING
Page 7–5 Drive System: Service and Repairs