Toro Z MASTER 2000 Series Service Manual page 64

Park Brake Handle Assembly Removal (continued)
Park Brake Handle Assembly Installation
Chassis: Service and Repairs
g336059
1. Locking Cotter Pin
2. Bolt
6. Remove the bolt and flange nut from the park brake lever assembly.
1. Connect the upper brake linkage to the brake shaft.
2. With the park brake handle hardware orientated as shown, install the bolt
and flange nut.
g336059
1. Locking Cotter Pin
2. Bolt
3. With the park brake shaft in disengaged position and the park brake lever in
the lower position, rotate the upper brake linkage until the end aligns with the
hole in the park brake lever.
Figure 43
3. Flange Nut
Figure 44
3. Flange Nut
Page 5–24 2000 Series Z MASTER® Service Manual
3438-778 Rev A