Configuring The Interface - Datalogic QuickScan 2500 Series Quick Reference Manual

USB Composite (Keyboard + COM)
•
USB for Magellan Scanners
•
Keyboard Wedge
•
Information and programming options for each interface
type are provided in this section. For defaults and addi-
tional information associated with each interface, proceed
to the corresponding chapter in the QuickScan™ 2500
PRG.

CONFIGURING THE INTERFACE

Scan the appropriate programming bar code to select the
interface type for your system.
NOTE: Unlike some other programming features
and options, interface selections require that you
scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scan-
ning an interface selection bar code.
Some interfaces require the scanner to start in
the disabled state when powered up. If additional
scanner configuration is desired while in this
state, pull the trigger and hold for 5 seconds. The
scanner will change to a state that allows pro-
gramming with bar codes.
1
Configuring the Interface
QUICK REFERENCE GUIDE
11