Advertisement
STORAGE
6. Remove the spark plugs and spray storage oil for 5 seconds in
each cylinder.
7. Spin the drive pulley for three complete revolutions by hand to dis-
tribute the storage oil to coat the cylinder walls.
8. Reinstall the spark plugs and tighten to specification.
E E - - T T E E C C E E n n g g i i n n e e - - 4 4 . . 5 5 " " a a n n d d 7 7 . . 2 2 " " D D i i g g i i t t a a l l D D i i s s p p l l a a y y
Follow these simple steps.
To engage the procedure, do the following:
1. Place the vehicle in a well ventilated area.
2. Start the engine and let it run at idle speed until it reaches its oper-
ating temperature (watch the coolant temperature on the display or
verify the rear heat exchanger becomes warm).
3. Push the SET (S) button to select odometer mode.
278
T T i i g g h h t t e e n n i i n n g g t t o o r r q q u u e e
Spark plug
28 ± 2 Nm (21 ± 1 lbf-ft)
Advertisement
