Advertisement
MAINTENANCE PROCEDURES
T T Y Y P P I I C C A A L L
1. Deflection O-ring aligned with slider shoe
7. Read load recorded by the upper O-ring on the tensiometer.
T T Y Y P P I I C C A A L L - - L L O O A A D D R R E E A A D D I I N N G G
1. Upper O-ring
8. Load reading must be as per the track deflection in the Technical
Specifications .
9. If load reading is not in accordance with the specification, adjust
track tension. Refer to Track tension adjustment .
T T r r a a c c k k T T e e n n s s i i o o n n A A d d j j u u s s t t m m e e n n t t
1. Remove the tether cord cap from engine cut-off switch.
2. Lift rear of vehicle and support it off the ground.
U U s s e e p p r r o o p p e e r r l l i i f f t t i i n n g g t t e e c c h h n n i i q q u u e e s s , , n n o o t t a a b b l l y y u u s s i i n n g g y y o o u u r r l l e e g g s s f f o o r r c c e e . . D D o o
n n o o t t a a t t t t e e m m p p t t t t o o l l i i f f t t t t h h e e r r e e a a r r o o f f v v e e h h i i c c l l e e i i f f i i t t i i s s a a b b o o v v e e y y o o u u r r l l i i m m i i t t s s . .
252
C C A A U U T T I I O O N N
Advertisement
