BRP Lynx E-TEC Series Operator's Manual page 237

Check plug
Filler plug
G G e e a a r r b b o o x x O O i i l l R R e e p p l l a a c c e e m m e e n n t t
G G e e a a r r b b o o x x O O i i l l D D r r a a i i n n i i n n g g
1. Place the vehicle on a level surface.
2. Place a drain pan under gearbox drain plug area.
3. Remove filler cap.
4. Remove the drain plug located at the bottom of gearbox.
1. Drain plug access hole
5. Wait a while to allow all oil to drain out of gearbox.
6. Install drain plug and tighten to specification.
Gearbox drain plug
G G e e a a r r b b o o x x O O i i l l F F i i l l l l i i n n g g
N N O O T T E E : :
Vehicle must be on a level surface.
t t i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
6 ± 1 Nm (53 ± 9 lbf-in)
8 ± 1 Nm (71 ± 9 lbf-in)
t t i i g g h h t t e e n n i i n n g g t t o o r r q q u u e e
MAINTENANCE PROCEDURES
6 ± 1 Nm (53 ± 9 lbf-in)
235