Table of Contents
Advertisement
9.
Slide the floppy drive assembly into the chassis until it clicks into place. See letter "A" in the figure below.
10. Open the connector on the backplane by pulling out on the connector cover. See letter "B" in the figure
below.
11. Insert the loose end of the floppy cable into the backplane connector. See letter "C" in the figure.
12. Push in on the connector cover to lock the cable into place. See letter "D" in the figure.
13. Install the chassis cover.
14. Install the front bezel.
Removing a Floppy Drive from the Slim Line Drive bay with Altos R710
1.
Power down the server system and unplug all peripheral devices and the AC power cable.
2.
Remove the chassis cover.
3.
Remove the front bezel.
4.
Open the connector on the rear of the floppy drive by pulling up on the connector.
5.
Remove the data cable from the rear of the floppy.
77
A
B
TP01144
C
Chapter 3
Advertisement
Table of Contents
Troubleshooting
