Table of Contents
Advertisement
8.
Align the holes in the drive to the holes in the drive carrier and attach it to the carrier with the screws that
were attached to the plastic retention device.
9.
With the black lever in the fully open position, slide the drive assembly into the chassis. Insert the primary
drive in the right bay. The green latch at the front of the drive carrier must be to the right. Do not push on
the black drive carrier lever until the lever begins to close by itself.
10. When the black drive carrier lever begins to close by itself, push on it to lock the drive assembly into place.
11. Install the front bezel.
Removing a Hot-swap Hard Disk Drive
1.
Remove the front bezel.
2.
Press in on the green latch at the front of the hard drive carrier.
3.
Pull out on the black lever to slide the carrier from the chassis.
4.
Remove the four screws that attach the hard drive to the drive carrier. Lift the drive from the carrier. Store
the drive in an anti-static bag.
5.
(optional) Place the plastic retention device into the drive carrier, using the four screws you removed from
the hard drive.
6.
Insert the screws that held the drive in the carrier into the screw locations on the carrier for future use.
7.
With the black lever in the fully open position, slide the drive carrier back into the chassis. The green latch
must be to the right. Do not push on the black lever until the lever begins to close by itself. See figure
"Insert
8.
When the black lever begins to close by itself, push on it to lock the drive carrier into place.
9.
Install the front bezel.
75
E
C
D
A
B
OM11684
Chapter 3
Advertisement
Table of Contents
Troubleshooting
