Maintenance And Care - Flex PE 8-4 80 Original Operating Instructions

Attaching or changing the tool
holder
Pull out the mains plug.

Press and hold down the spindle lock.

Screw chuck clockwise onto the spindle

and tighten hand-tight.
To loosen, turn chuck anti-clockwise.
Attach or change tools
Pull out the mains plug.

Press polishing agent firmly in the centre

of the Velcro pad. Use undamaged
polishing tools only.
Carry out a test run to check that the tool

is clamped in the centre.
Operating instructions
NOTE
When the power tool is switched off, the tool
continues running briefly.
– If using a polishing paste, use the
respective tool for each paste.
18
– In the case of sensitive surfaces
(e. g. car paint) do not work aggressively,
but at low speeds and with low contact
pressure.
– Sponges can be washed in the washing
machine.

Maintenance and care

WARNING!
Before carrying out any work on the
polisher, always pull out the mains plug.
Cleaning
WARNING!
If metals are work over a prolonged period,
conductive dust may become deposited
inside the housing. Impairment of the
protective insulation! Operate the power tool
via a residual-current-operated circuit-
breaker (tripping current 30 mA).
Regularly clean the power tool and

ventilation slots. Frequency of cleaning is
dependent on the material and duration
of use.
Regularly blow out the housing interior

and motor with dry compressed air.
Carbon brushes
The polisher features cut-off carbon
brushes.
When the wear limit of the cut-off carbon
brushes is reached, the polisher switches
off automatically.
NOTE
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the polisher is being used, the carbon
brushes can be seen sparking through the
rear air inlet apertures.
If the carbon brushes spark excessively,
switch off the polisher immediately. Take the
polisher to a customer service workshop
authorised by the manufacturer.
PE 8-4 80