Table of Contents
Advertisement
1. Soldering Cord Extension Holder
2. Soldering Iron Holder
3. Temperature Control Buttons
4. Bright White LED Display
5. Calibration Control Buttons
6. Function Buttons
7. Soldering Iron
8. Wet Sponge Holder
9. Brass Sponge Holder
1. Open the package and check that all parts are present and are
not damaged. If anything is missing or damaged, please contact
X-Tronic immediately for assistance (see back cover for contact
information).
2. Remove everything from the packaging.
3. Place the soldering cord extension holder in the bracket on the
right hand side (see #1 in drawing above).
4. Plug the soldering iron into the back of the unit and place the
soldering iron in the soldering iron holder (see #2 in drawing
above). Secure the core in the extension holder (optional).
5. The brass sponge is in the silicone opening right below the
soldering iron (see #9 in drawing above).
6. Wet the blue sponge and place in the space at the base of the
soldering iron holder (see #8 in drawing above).
7. Plug the 3-prong AC cord into the back of the unit and then into a
grounded outlet to prevent electric shock or injury.
UNIT PARTS
5
7
INITIAL SET - UP
- 4 -
4
6
1
2
3
9
8
Advertisement
Table of Contents
