Replacing The Fuse; Troubleshooting - X-Tronic 4010-PRO-X Instructions Manual

REPLACING THE FUSE

Fuse
Compartment
1. Unplug the power cord from the outlet.
2. Remove the fuse compartment by pressing a flat head screwdriver
into the divot just inside the power socket under the fuse
compartment.
3. The fuse that is in use will be in the fuse clip, the extra fuse is
below it. If the fuse is damaged, replace it with the new fuse.
4. Insert the fuse compartment back into the unit.
ISSUE
Unit does not
have power
S-E Error
Tip is not
heating up as
expected

TROUBLESHOOTING

POSSIBLE SOLUTIONS
• Ensure the power cord is securely attached to both
the unit and the outlet and that the unit is powered
on at the back of the unit.
• Ensure that the outlet is functional.
• Check the fuse in the back of the unit to see if it is in
good working condition. If not, replace fuse.
• Ensure the soldering iron is securely plugged into
the back of the unit.
• The heating element may need to be replaced
• Ensure the soldering iron is securely plugged into
the back of the unit.
• The soldering tip could be oxidized, it is important
to always tin your tip and keep it clean. See Tip
Maintenance section of manual.
• The heating element may need to be replaced
• Unit may need to be calibrated - see Calibration
section of manual
Fuse Clip
Extra Fuse
Compartment
Fuse
- 11 -