Inspection And Maintenance Schedules; Parts Ordering - Emerson EL-O-Matic F-Series Safety Manual

Safety Guide
DOC.SG.EF.EN Rev. 2

2.2 Inspection and Maintenance Schedules

The EL-O-Matic F Rack and Pinion actuators must be inspected periodically and
maintained as needed. Refer to the maintenance section of manual DOC.IOM.EF.EN
for more detailed information.
The schedule for inspection can only be determined based on the severity of your
service conditions. Your installation might also be subject to inspection schedules
set by applicable governmental codes and regulations, industry standards, company
standards, or plant standards.
In order to avoid increasing dust explosion risk, periodically clean dust deposits from
all equipment.
When equipment is installed in a hazardous area (potentially explosive atmosphere),
prevent sparks by proper tool selection and avoiding other types of impact energy.
Proper care must be taken to avoid generation of static electricity on the non-
conductive external surfaces of the equipment (e.g. rubbing of surfaces, etc.). The
actuator's surface temperature is dependent upon process operating conditions.

2.3 Parts Ordering

When ordering parts for older products, always specify the type, size and serial
number of the product and provide all other pertinent information that you can,
such as part material, age of the product, and general service conditions. If you have
reconfigured the product since it was originally purchased, include that information
with your request.
WARNING - USE GENUINE PARTS
Use only genuine replacement parts. Components that are not supplied by Emerson should not,
under any circumstances, be used in any EL-O-Matic product. Use of components not supplied
by Emerson may void your warranty, might adversely affect the performance of the product,
and could cause personal injury and property damage.
EL-O-Matic F-Series
April 2018
2
EN