Table of Contents
Advertisement
K3NC
Precautions
Be careful not to touch any terminals, otherwise you may receive
an electric shock.
Please do not disassemble the product nor touch the internal
components of the product, otherwise you may receive an
electric shock.
Be sure that the power supply voltage is within the rated range.
Do not use the Intelligent Signal Processor in locations with
flammable gas or combustible substances.
Be sure to wire the terminals correctly by checking the terminal
names.
Be sure that the terminal screws are tightened securely when
wiring.
Mounting
Recommended panel thickness is 1 to 3.2 mm.
Panel
Attach the mounting bracket on the left and right sides of the Intelli-
gent Signal Processor as shown in the illustration above and gradu-
ally tighten each screw evenly in turn by considering the balance of
the tightening force until the ratchets start slipping without being fur-
ther tightened.
Mount the Processor as horizontally as possible.
Never use the Processor in locations where corrosive gas (particu-
larly sulfur or ammonia gas) is generated.
As much as possible avoid use of the Processor in a location subject
to severe shock or vibration, excessive dust, or excessive moisture.
Select an indoor mounting location where the Intelligent Signal Pro-
cessor is at the rated temperature and humidity and free from direct
sunlight.
Separate the Processor from machines generating high-frequency
noise, such as high-frequency welding machines and high-frequen-
cy sewing machines.
Operation
A Processor model with a Relay Contact or Transistor Output Board
may not output any alarm signal normally if the model has an error. It
is recommended that an independent alarm device be connected to
the model.
The parameters are factory-set so that the Processor will operate
normally. The settings of the parameters may be changed accord-
ing to the application.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. N089-E1-1A In the interest of product improvement, specifications are subject to change without notice.
OMRON Corporation
Supervisory Control Devices Division
28th Fl., Crystal Tower Bldg.,
1-2-27, Shiromi, Chuo-ku,
Osaka 540-6028 Japan
Phone: (81)6-949-6035 Fax: (81)6-949-6069
16
Unit Label (Attached)
No product is shipped with the unit label attached. Select a unit label
from the sheet provided and attach it to the Processor.
K3NC
Printed in Japan
0698-1M (1297) a
Advertisement
Table of Contents
