Force Pair To Device - Kramer KDS-USB2 User Manual

Kramer Electronics Ltd.

3.23 Force Pair To Device

This command is sent by a client to a device to instruct the device to clear all of its existing pairings and
then try to pair with a different device specified in this message. A client must send this message to a
ENCODER and a DECODER to instruct them to pair together, but the order of the two messages does
not matter. The device will respond with an Acknowledge message if it is able to pair with a new
device or a Negative Acknowledge message otherwise. The transmission of the Acknowledge
message only indicates that an attempt will be made to establish a link between the devices, not that a
link is already established.
3.23.1 Field Descriptions
Pair To Device MAC Address
Byte Offset
+-----------------------------------------+-----------------------------------------+
0 | Magic Number
+
2 |
+-----------------------------------------+-----------------------------------------+
4 | Message ID
+
6 |
+-----------------------------------------+-----------------------------------------+
8 | Protocol Version = 3
+-----------------------------------------+-----------------------------------------+
10 | Force Pair To Device MAC Address
+
12 |
+
14 |
+-----------------------------------------+-----------------------------------------+
SwitchableUSB – 3
The MAC address that the client is telling the device to attempt to pair
with.
Supported Messages
| Command = 18
|
+
|
|
+
|
|
|
+
|
+
|
31