Use Static Ip - Kramer KDS-USB2 User Manual

Kramer Electronics Ltd.

3.12 Use Static IP

Sent by a client to a device to tell a device that it should use the static network configuration contained
within this message. The IP, subnet mask and default gateway as well as the network configuration
are stored in permanent storage, so the device will keep the same network configuration after being
power cycled. Similarly to the Use DHCP message, this message may be broadcast or sent to a
specific device. An acknowledge message will always be sent back to the client when a Use Static IP
message is received by a device providing that the Target MAC Address parameter matches the MAC
address of the device. Sending a Use Static IP message to a device already in a static configuration
will enable a client to change the IP, subnet mask or default gateway of the device.
3.12.1 Field Descriptions
Target MAC Address
IPv4 Address
Subnet Mask
Default Gateway
Byte Offset
+-----------------------------------------+-----------------------------------------+
0 | Magic Number
+
2 |
+-----------------------------------------+-----------------------------------------+
4 | Message ID
+
6 |
+-----------------------------------------+-----------------------------------------+
8 | Protocol Version = 3
+-----------------------------------------+-----------------------------------------+
10 | Target MAC Address
+
12 |
+
14 |
+-----------------------------------------+-----------------------------------------+
16 | IPv4 Address
+
18 |
+-----------------------------------------+-----------------------------------------+
20 | Subnet Mask
+
22 |
+-----------------------------------------+-----------------------------------------+
24 | Default Gateway
+
26 |
+-----------------------------------------+-----------------------------------------+
SwitchableUSB – 3
The MAC address of the device which will be set to use static network
configuration.
The IPv4 address being assigned to this device encoded as a 32 bit
integer.
The subnet mask of the network that this device is on.
Sets the default gateway of the device.
Supported Messages
| Command = 7
|
+
|
|
+
|
|
|
+
|
+
|
|
+
|
|
+
|
|
+
|
18