Save & Exit - DFI AL9A2 User Manual

Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Main Advanced Security Boot
Setup Prompt Timeout 1
NumLock [On]
Quiet Boot [Disabled]
Network Stack [Enabled]
Ipv4 PXE Support [Enabled]
Ipv6 PXE Support [Disabled]
Boot Option Priorities
Driver Option Priorities
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Ipv4 PXE Support
When enabled, Ipv4 PXE boot supports. When disabled, Ipv4 PXE boot option will not
be created.
Ipv6 PXE Support
When enabled, Ipv6 PXE boot supports. When disabled, Ipv6 PXE boot option will not
be created.
Boot Option Priorities
Sets the system boot order.
Driver Option Priorities
Sets the driver boot order.
Note:
AL9A2 only supports UEFI boot, no Legacy
Chapter 4 BIOS Setup
Save & Exit
Enable/Disable UEFI Ipv4
Ipv6 PXE Boot Support
Select Screen

 Select Item
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
boot.
Chapter 4
Save & Exit
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Main Advanced Security
Exit Saving Changes
Load Optimal Defaults
Discard Changes
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Exit Saving Changes
Select Yes and then press <Enter> to exit the system setup and save your changes.
Load Optimal Defaults
Select Yes and then press <Enter> to load optimal defaults.
Discard Changes
Select Yes and then press <Enter> to exit the system setup without saving your
changes.
35
Save & Exit
Boot
Reset the system after
saving the changes.
 Select Screen
Select Item

Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
www.dfi .com