Table of Contents
Advertisement
ACPI Configuration
This section is used to configure ACPI settings.
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Advanced
[Disable]
Wake On Lan
[Always On]
After G3
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Wake On Lan
Enable or Disable this field to use the LAN signal to wake up the system.
After G3
This field is to specify what state the system should be in when power is re-applied
after a power failure (G3, the mechanical-off, state).
Always On
The system is in working state.
Always Off
The system is in soft-off state, except for trickle current to devices such
as the power button.
Chapter 4 BIOS Setup
Chapter 4
Enable or Disable the
Wake on Lan
Select Screen
Select Item
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
27
Note:
If Quiet Boot is set to enabled, BGRT Logo field will appear for configuration. Refer
to the Boot menu for more information.
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Advanced
Wake On Lan
[Disable]
[Always On]
After G3
[Enabled]
BGRT Logo
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
BGRT Logo
This field is used to enable or disable to support display logo with ACPI Boot Graphics
Resource Table.
Boot Graphics Resource
Table
Select Screen
Select Item
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
www.dfi .com
Advertisement
Table of Contents
