Naming A Memory Channel - Yaesu FTM-3200DE Advance Manual

Naming a Memory Channel

You may wish to append an alphanumeric "Tag" (label) to each memory, to aid in
recollection of the channel's use (such as club name, etc.).
1. Recall the memory channel on which you wish to append a label.
2. Press and hold in the [ MHz ( SETUP )] key for
one second to enter the Set mode.
3. Rotate the DIAL knob to select "MEM NAME
24".
4. Press the [ MHz ( SETUP )] key momentarily to
enable programming of the nametag.
5. Rotate the DIAL knob to select the first digit
of the desired label.
6. Press the [ V/M ( MW )] key to move to the next
character.
Note: To make a correction, press the
[ SQL ( TXPO )] key to back-space the
cursor, then re-enter the correct letter,
number, or symbol.
7. Repeat steps 5 through 6 to program the re-
maining letters, numbers, or symbols of the
desired label. A total of 8 characters may be
used in the creation of a label.
8. When you have programmed a label that is
under 8 characters, press the [ MHz ( SET-
UP )] key to confirm the label.
Note: Press and hold in the [ REV ( DW )] key for one second to delete all data after the
cursor that may have been previously stored.
9. When you have completed the creation of the label, then press and hold in the
[ V/M ( MW )] key for one second to save the label and exit.
While operating in the Memory Recall mode,
press the [ MHz ( SETUP )] key to toggle the
display between indication of the frequency,
and indication of the Alpha/Numeric label.
FTM-3200DR/DE Advance Manual
Memory Operation
VOL
SQL REV D/A M H z V / M
TXPO D W M W
SETUP
DIAL
15