Table of Contents
Advertisement
Table 75 Security > Firewall > Protocol: Add/Edit (continued)
LABEL
Protocol
Source/
Destination Port
Protocol
Number
ICMPv6 Type
OK
Cancel
17.4 The Access Control Screen
Click Security > Firewall > Access Control to display the following screen. This screen displays a list of the
configured incoming or outgoing filtering rules.
Figure 124 Security > Firewall > Access Control
The following table describes the labels in this screen.
Table 76 Security > Firewall > Access Control
LABEL
Add New ACL
Rule
#
Name
Src IP
Dst IP
Service
Chapter 17 Firewall
DESCRIPTION
Choose the IP protocol (TCP, UDP, ICMP, ICMPv6 or Other) that defines your customized port
from the drop-down list box. Select Other to be able to enter a protocol number.
These fields are displayed if you select TCP or UDP as the IP port.
Select Single to specify one port only or Range to specify a span of ports that define your
customized service. If you select Any, the service is applied to all ports.
Type a single port number or the range of port numbers that define your customized service.
This field is displayed if you select Other as the protocol.
Enter the protocol number of your customized port.
This field is displayed if you select ICMPv6 as the protocol.
Enter the type value for the ICMPv6 messages.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Click this to go to add a filter rule for incoming or outgoing IP traffic.
This is the index number of the entry.
This displays the name of the rule.
This displays the source IP addresses to which this rule applies. Please note that a blank source
address is equivalent to Any.
This displays the destination IP addresses to which this rule applies. Please note that a blank
destination address is equivalent to Any.
This displays the transport layer protocol that defines the service and the direction of traffic to
which this rule applies.
EMG6726/8726-B10A User's Guide
189
Advertisement
Table of Contents
